Home / High Flexible Tile Adhesive TA500 C2TES1

High Flexible Tile Adhesive TA500 C2TES1

Customize your products in every detail, we provide customized service for you. If you have any requirements on the shape, dimensions, function, or other aspects of your products, or if you have any new creative products to be developed, you can contact our team and we will work out the most cost-effective production plan for you.
Quantity
ADD TO CART
BUY IT NOW
  • Detail

    High Flexible Tile Adhesive TA500 C2TES1

    Product Description

    EasyMix Flexible Tile Adhesive TA500 C2TES1 is anImproved slip resistant(T)cementitious adhesive (C)with extended open time (E)and deformation(S1)classified asC2TES1 cassification in compliance withJC/T547 and EN 12004.It is made of quality cement special selected fine aggregateand polymer additives in a reasonableproportion. lt hasproperties of flexibility, long open time, excellent adhesionand anti-slip.

    Product usage

    Suitable for indoor and outdoor, bathroom, kitchen wall and floor big tiles, large tiles and natural stone

    Specification & Technical data：JC/T 547-2017 C2TES1/BS EN 12004

    Testing items
    C2TES1
    Tensile adhesion strength ( MPa)
    ≥1.0
    ( MPa) Tensile adhesion strength after water immersion
    ≥1.0
    ( MPa) Tensile adhesion strength after heat aging
    ≥1.0
    ( MPa) Open time, 20min tensile adhesion strength(MPa)
    ≥1.0
    Extended open time, 30mintensile adhesion strength(MPa)
    ≥0.5
    Slip ( mm)
    ≥0.5
    Transverse deformation（ mm）
    ≥2.5 ，＜5


    Application

    1，SubstrateSurfacePreparation

    1.Make sure that the substrate surface is clean and saturated wet without free running water on the surface.
    2.    Defects in the substrate surface should be repaired beforehand, and knock-outs if there are bumpsand it is recommended to use EasyPlas repair mortar to repair.
    3.    Concrete walls and cement mortar plaster surfaces should be matured to required strength beforeapplication.

    2，Mixing

    1.In the appropriate container, first pour a measured amount of water, and then slowly add the drypowder according to the proportion, use the electric mixer to mix fully atlow speed for 3-5 minutes, while pouring the powder and mixing to a uniform slurry (similar to paste) without lumps and without precipitation. Let it stand for 1 ~2 minutes,then mix for 1 ~2 minutes to use.
    2.    Do not add any material outside of the ratio to the tile adhesive, including excessive water, cement,or river sand.

    3，Application

    1.Ensure that the substrate surface is saturated wet and free of surface running water.Apply evenlya laver of adhesive onto the substrate surface with an appropriate notched trowel and comb intoa stripe form.Note : use the proper sized notched trowel to ensure full bedding of the tile.
    2.Next, butter the back of the tile with athin layer of adhesive mortar.
    3.To inspect whether the tile is fully embedded onto the substrate, just pull out one of the tile while themortar still wet , check the coverage of the adhesive mortar on theback side of tile is itcompliance with the requirement .
    4.Adjust the height, thickness and vertical elevation of tiles
    5.Plastic positioning crosses are inserted into the brickjoints to ensure that there are gaps between the tiles    to reduce stress induced damage.

  • Customer Reviews
    No comments
BACK